T2000WD/1

2000 Watts x 1 Peak Power
1000 Watts RMS x 1 at 2 ohm
Mono block - single channel amplifier
Mosfet Powered
Push pull switching power supply
Low/High Level inputs and outputs
THD: > 0.016 %
Signal/Noise Ratio: >104dB
Frequency Response: 10Hz-400Hz
Crossover Frequency, LPF: 50Hz-300Hz
Bass Boost: 0dB-10dB
Subsonic: on/off
0-180 degree Phase shift
Low Level: 200-4v
High Level: 0.5-5v
Low Level: 10k Ohms
High Level: 100 ohms
(2) 30 amp fuses
4-gauge power connection
8-gauge speaker connection
Dimensions: 2.31" x 9.75" x 13.3125"
Remote Gain control included

mono subwoofer amplifier
330 watts RMS x 1 at 4 ohms
600 watts RMS x 1 at 2 ohms
CEA-2006 compliant
Dynamic Distortion Suppressor and Active Thermal Control
variable low-pass filter (50-300 Hz)
variable bass boost (0-10 dB at 40Hz)
Class-D amplifier design
frequency response: 10-300 Hz
speaker- and preamp-level inputs
1 pair preamp outputs
fuse rating: 30A x 2
8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
14-1/8"W x 2-1/4"H x 11"D

4-channel marine amplifier
4- or 3-channel output (no 2-channel operation)
conformal coated circuit board
gold-plated connectors
line- and speaker-level inputs
pulse power supply for stable and regulated output power
60 watts RMS x 4 at 4 ohms
60 watts RMS x 2 + 150 watts RMS x 1 in 3-channel mode
built-in low-pass filter: 80 Hz, 18 dB per octave
built-in high-pass filter: 80 Hz, 12 dB per octave
CEA-2006 compliant
15-7/8" W x 2-1/4" H x 10-3/8" D

500 Watts Maximum Power
4 Channels: 50 Watts x 4 Ch @ 4 ohms
3 Channels: 95 watts x 2 Ch + 205 Watts x 1 Ch @ 4 ohms
Bridged into 4 ohms: 95 watts x 2 +  250 watts x 1
Frequency Response: 5Hz-100kHz
Low Pass Filter: 80Hz, -18dB/oct
High Pass Filter: 80Hz, -12dB/oct
Low Boost: 0-10dB (40Hz)
Power Requirements: 12v DC car battery
Power supply voltage 10.5-16V
Signal to noise ratio (DB): 106DB
Speaker Terminal Outputs
RCA pin jacks inputs
Dimensions: 8 7/8" x 1 3/4" x 7 3/4"
Mounting Screws (4)
High level input cord (1)
CEA-2006 Power Compliant
Fits under the seat for F150, Ram 1500, Silverado
Fuse: 40A x 1

900 watts max power @ 2 ohm
600 watts max power @ 4 ohm
500 Watts RMS @ 2 ohm
290 watts RMS @ 4 ohm
Class D Technology
Pulse Power Supply
Low boost switch: 0-10dB (40Hz)
Subsonic filter: 15Hz, -12dB/oct
Low Pass Filter: 50-300Hz, -12dB/oct
Input level adjustment range:
0.3-6.0V (RCA Pin Jacks)
6.0-16.0V (High level input)
Active Thermal control
Line level thru-put
Line & speaker level inputs
CEA-2006 Power Compliant
Signal to Noise Ratio:
65dBA (reference 1 W into 4 ohm)
90dBA (reference rated power into 4ohm)
Frequency Response: 5-300Hz
Dimensions: 8 7/8" x 1 3/4" x 7 3/4"
Mounting Screws (4)
High leve input cord (1)
Fits under the seat for F150, Ram 1500, Silverado and other compact vehicles
Fuse: 30A x 2

Mono Channel Car Amplifier
200 watts x 1 ch @ 4 ohm
300 watts x 1 ch @ 2 ohm
450 watts x 1 ch @ 1 ohm
Power Supply: PVM
Output Power Circuit Configuration: Mosfet
Soft Start Sound: Yes
input Selector S/W: No
Frequency Response -3dB : 15Hz - 300kHz
Damping Factor: >250
S/N Ratio: >95dB
THD: 0.10%
Variable Input Level Control: 0.2V - 9.0V
Diagnostic Indicator: Power/Protect
Protection (DC, Short, Thermal, Overload): Yes
variable Low-pass: 30Hz - 120Hz / 12 - 24dB
Variable subsonic filter: 15Hz - 50Hz
Bass Boost: 0 ~ 9dB
Unbalanced Input (RCA Jack): Yes
Phone Jack for Remote Control: Yes
Bass Boost Remote Control: Yes
Gold Plated Power Terminal: 4 Gauge
Gold Plated Speaker Terminal: 10 Gauge
Fuse: 2 x 25A
Dimensions (L/H/W): 9.84 x 2.03 x 8.3 inches

2 Channel Car Amplifier Class A/B
Maximum Power: 1500 watts
RMS Power:
100w x 2 @ 4 ohm
150w x 2 @ 2 ohm
250w x 1 Bridged @ 4 ohm
S/N Ratio: 90dB
Variable Low Pass Filter: 45Hz~300Hz
Variable High Pass Filter: 45Hz~1.2KHz
Bass Boost: 0dB to +12dB
Fuse Rating: 25A x 2 each
Input Sensitivity: 200mV~6V
Remote Bass Boost Control
High efficiency heat sink
Nickel plated terminals
Bridgeable
Dimensions (L x W x H): 15 1/2" x 9 1/4" x 2 1/4"

600w RMS x 1 @ 4 ohm
800w RMS x 1 @ 2 ohm
1200w RMS x 1 ch @ 1 ohm
Soft Start Sound: Yes
Frequency Response: 15hz-300hz
Damping factor: >260
S/N ratio: >95 dB/min
THD: 0.10%
variable input level control: 0.2v - 6.0v
input impedance: 47kOHM
Diagnostic Indicator: Power/Protect
Protection (DC, Short, Thermal, Overload): Yes
variable low pass (mono 24dB): 35hz-250hz
variable subsonic filter: 15hz-25hz
bass boost at 45hz: 0 ~ 9dB
Line Output: full range
Unbalanced input ( RcA jack ): yes
Balanced line input ( DIN ): yes
Phone jack for remote control : yes
Fuse Size: 2 x 40A
Dimenesions: 17 x 2.25 x 10.4"
Super Class D Amplifier topology
Stable @ 1 ohm loads
High Speed MOSFET Output Devices
Focused Mass Aluminum Heat Sink
PWM Power Supply
Band Pass Capable Crossover
Vario bass equalizer circuit
variable 24dB subsonic filter
Full range preamp outputs
Remote bass level control included
2 gauge power & ground inputs
4 stage amplifier protection circuit
wire concealing end panels

RMS @ 4ohm: 100W x 4 ch
RMS @ 2ohm: 200W x 4 ch
RMS @ 4ohm Bridged: 320W x 2ch
Maximum Power Output: 800W
Variable Low Pass Filter: 50Hz~250Hz
Variable High Pass Filter: 80Hz~1.2kHz
Frequency Response: 10Hz-40kHz
Signal to Noise Ratio: >100dB
Input Sensitivity: 200mV - 6V
Input Impedance: 22k Ohms
Operation Voltage: DC 12V
Speaker Impedance @ stereo Driven: 4 ohms
Crossover Selector Switch: HP/LP/FLAT
Bridgeable & TRI-Mode Operation
Gold Plated RCA & Power, Speaker Terminal
Soft Start & Muting
Power & Protection indicator
Protection against short, thermal and overload
Fuse Rating: 25A x 2 each
Dimensions (mm): 260 x 56.5 x 350